Turn signal lever

1. Right turn.


1. Right turn.

2. Left turn.

3. Move and hold the lever partway to signal a lane change.

The right hand signal will flash until you release the lever.

4. Move and hold the lever partway to signal a lane change.

The left hand signal will flash until you release the lever.

Turn signals can be operated when

The “ENGINE START STOP” switch is in IGNITION ON mode.

If the indicators flash faster than usual

Check that a light bulb in the front or rear turn signal lights has not burned out.

    See also:

    Front seats
    1. Seat position adjustment switch. 2. Seatback angle adjustment switch. 3. Seat cushion (front) angle adjustment switch. 4. Vertical height adjustment switch. 5. Lumbar support adjustment switc ...

    General maintenance
    Listed below are the general maintenance items that should be performed at the intervals specified in the “Warranty and Service Guide” or “Owner’s Manual Supplement”. It is recommended that any prob ...

    Ashtray
    Push the back part of the lid to open. To remove, pull the ashtray upwards. CAUTION: When not in use Keep the ashtray closed. Injuries may result in the event of sudden braking, sudden swervi ...