Turn signal lever
The turn signal lever can be used to show the following intention of the driver:
1. Right turn.
2. Left turn.
3. Lane change to the right (push and hold the lever partway).
The right hand signals will flash until you release the lever.
4. Lane change to the left (push and hold the lever partway).
The left hand signals will flash until you release the lever.
Turn signals can be operated when
The “POWER” switch is in ON mode.
If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
See also:
General maintenance
Listed below are the general maintenance items that should be performed
at the intervals specified in the “Warranty and Service Guide” or “Owners
Manual Supplement”. It is recommended that any probl ...
Active Safety
The new Lexus CT 200h may be equipped with a sophisticated Pre-Crash Safety
system (PCS) that can help reduce collision damage and injury. It employs a
millimetre wave radar sensor to detect objec ...
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle
becomes
stuck in mud, dirt, or snow.
Stop the engine. Set the parking brake and put the shift lever in P.
- Remove the mud, sno ...