Your preferred front passenger seat position can be memorized and recalled with the touch of a button.

Two different seat positions can be entered into memory.

Entering a position to memory

Turn the “ENGINE START STOP” switch to IGNITION ON mode.

Adjust the front passenger seat to the desired position.

Push the “SET” button, then within 3 seconds push button 1 or 2 until the signal beeps.

If the selected button has already been preset, the previously recorded position will be overwritten.

Recalling the memorized position

Check that the shift lever is set in P.

Push button 1 or 2 to recall the memorized position.

Retained accessory power

Memorized position can be activated up to 180 seconds after the front passenger
door is opened, even after turning the “ENGINE START STOP” switch OFF.

To cancel seat position recall

Perform any of the following operations.

- Push the “SET” button.

- Push button 1 or 2.

- Adjust the seat position using the switches.

If the battery is disconnected

The memorized positions are erased when the battery is disconnected.

CAUTION:
Seat adjustment caution
Take care during seat adjustment that the seat does not strike the rear passenger.