The multi-information display presents the driver with a variety of drivingrelated
data including the current outside air temperature.

Multi-information switches

1. Menu switch.

Changes modes to electronic features control mode, customization mode or back to normal
display mode
2. “ENTER” switch.

Changes trip information items.

This switch is also used to turn on/off electronic features controls and to change customization settings.

Display contents

Display order may vary depending on vehicle condition.

Trip information

Energy monitor

Displays the status of the hybrid system.

Current fuel consumption

Displays the current rate of fuel consumption.

Average fuel consumption after refueling

Displays the average fuel consumption since the vehicle was last refueled.

Average fuel consumption

Displays the average fuel consumption since the function was reset The function can be reset by pushing the “ENTER” switch for longer than one second when the average fuel consumption is displayed.

Average vehicle speed

Displays the average vehicle speed since the function was reset The function can be reset by pushing the “ENTER” switch for longer than one second when the average vehicle speed is displayed.

Cruising range

Displays the estimated maximum distance that can be driven with the quantity of fuel remaining.

• This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.

• When only a small amount of fuel is added to the tank, the display may not be updated.

Tire inflation pressure

Displays inflation pressure of each tire. There is no correlation between the order of the displayed values and the tire positions.

If the inflation pressure of any tire drops a certain amount below the tire inflation
pressure value currently memorized in the system, the displayed values will be highlighted.

It may take a few minutes to display the tire inflation pressure after the “POWER” switch is turned to ON mode. It may also take a few minutes to display the tire inflation pressure after inflation pressure has been adjusted.

If the tire pressure warning light is on or flashing, a message describing the situation will be displayed.

Electronic features control can be turned on/off when

The “POWER” switch is in ON mode.

Conditions for ending electronic features control

In the following situations, the electronic features control will end: The menu switch is pressed.

The radar cruise control is operated.

Intuitive parking assist starts operating.

No action is performed for some time after the electronic features control screen is displayed.

A warning message appears after the electronic features control screen is displayed.

Outside temperature display

In the following situations, the correct outside temperature may not be displayed, or
the display may take longer than normal to change.

When stopped, or driving at low speeds (less than 15 mph [25 km/h]).

When the outside temperature has changed suddenly (at the entrance/exit of a garage, tunnel, etc.).

Customization

Settings (e.g. available languages) can be changed.

CAUTION:
Caution while driving
When operating the electronic features control while driving, take extra notice of
the vehicle's surrounding area.

NOTICE:
The multi-information display at low temperatures Allow the interior of the vehicle to warm up before using the liquid crystal information
display. At extremely low temperatures, the information display monitor may respond slowly, and display changes may be delayed.