Turn signal lever
1. Right turn.
2. Left turn.
3. Move and hold the lever partway to signal a lane change.
The right hand signal will flash until you release the lever.
4. Move and hold the lever partway to signal a lane change.
The left hand signal will flash until you release the lever.
Turn signals can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
See also:
Driving the vehicle
The following procedures should be observed to ensure safe driving.
Driving
With the brake pedal depressed, shift the shift lever to D.
Release the parking brake.
Gradually release the brake peda ...
Moon roof
Use the overhead switches to open, close, and tilt the moon roof up and
down.
Opening and closing
Standard type
1. Open.
The moon roof stops slightly
before the fully opened position.
Push th ...
Pre-Collision System
When the radar sensor detects an unavoidable frontal collision, safety
systems
such as the brakes and seat belts are automatically engaged in an
attempt to lessen vehicle damage.
Pre-collision se ...